Clutch slip?

In the office at the moment @Alex,

Symptoms are on corner exit in the acceleration phase the gear appears not to engage until either shift (up or down) or reset throttle (ie back off and apply again) is unfortunately intermittent but tends to materialise through slower corners....

 

Same problem as I am getting.

 

Hi @Alex Hodgkinson, don't know what you and the team did but the issue seems to be resolved... No changes on my side, so it must have come from you
Thanks so much for the support
RJ

 

Same here, problem appears fixed

 

Hi again @Alex Hodgkinson , problem with clutch slip on the LOTUS that was solved earlier has come back on the Nordschleife VLN circuit coupled with the ERROR 13 at session end .... same symptoms as before....
Greets from Luxembourg
RJ

 

Hi again @Alex Hodgkinson , problem with clutch slip on the LOTUS that was solved earlier has come back intermittently on Redbull ring more so on the hill climb.... I'm now not sure if it is a feature because it is happening more as I hit the curb on the apex and go into the acceleration phase of corner exit... Almost as if the inside wheel is lifting and there is no LSD... revs out until (a.) back off or (b.) change gear.... also tried just keeping the revs on and rolling..... doesn't correct..... Any suggestions from anyone? This is sort of starting to affect the overall enjoyment....

 

I’m getting clutch slip on the group 5 Capri on Bathurst, I’ll make a video later today and upload it.

 

Hi @Alex Hodgkinson thanks for the response, here you go....

 

Hi @Alex Hodgkinson first is with a change up to solve , second is foot from gas to try and reset.... bit of a pain in the arse mid-corner though
RJ

 

Hey @Alex Hodgkinson .... I'm thinking throttle sensitivity too high, or am I being dim?

 

I saw a similar issue before where someone didn't have a clutch pedal assigned/calibrated. Calibrating the clutch fixed it for them, not sure if this is the same issue, but looks similar.

 

Hey @Scout, thanks for that.... lets give it a try

OK.... Lower dead zone 0% Upper 100% Sensitivity 50% (so not been touched)

Now the magic part.... calibrate a clutch that is disconnected

 

A friend and I had the same problems as described in the thread and in the videos.
Things like
- unbind clutch, plugoff clutch unit completly
- reinstall PC
- new initialization of the Dokument folder
didn't worked out

Issue Timetable:
Me -> like 1 year ago
Friend -> couble month ago

Now no issues since back then