Well done guys , now to get some classic stuff too
The exact reason I popped in
Thanks Christian ,have they not had this problem for a while with fanatec? I’m sure I remember from a few years ago there was the same issue. I...
This will be my next point of action to stop it but I thought I’d just run it by some people in case there was another way. Thanks for your reply.
I keep getting the error “one of your inputs is missing”. I have a Fanatec setup on the newest driver and firmware, it’s the pedals that are...
Your setup is awesome, I got to to 297 and 17th in the Uk beating the driver promoting the competition. Thanks for sharing I’ll be at it this...
Put it into CSW compatibility mode , should work fine until sector 3 put a profile in . I don’t have one until next month but I’ve been reading a...
I’m getting clutch slip on the group 5 Capri on Bathurst, I’ll make a video later today and upload it.
Just ordered the DD1 before the price hike , looking forward to it . I honestly thought there would be a profile in r3e for it as the devs do...
I’m sure the setup is from “Tom the Dentist “ a quick driver in gamermuscles community, try on his discord for the setup
This is a problem with Fanatec pedals at the minute see this thread ,it is known about by the devs...
I brake early usually as I can use it as advantage in the corner , also if the driver in front is a little iffy I keep well back anyway
i should have put i was driving,then paused, checked the leaderboard, meanwhile the disconnect notices were spamming the top of my screen. Not...
Having a lot of trouble with this today after rebooting my pc,disconnected about 10 times just while I checked the leaderboard before driving...
Your wheel should now automatically change its rotation per car.
@Karting06 its not a hardware problem mate it happens to me too all the time. As soon as you come out of driving you start to get messages...
I also get these messages “connected disconnected “ also when I delete my control profile and start again it doesn’t always recognise my csp v3’s....
Max front and A few clicks down from max on the rear
I took the camber to almost max and dropped the rear toe down to 36. It really helped in handling and stopped the car stepping out all the time. I...
I’ve registered for the first race to give other a chance,I do hope that all drivers aren’t aliens. I mean I’m ok on nords but hope I don’t get...
Separate names with a comma.