ADAC GT Masters Experience 2014 on Bathurst Circuit - SETUP

Discussion in 'General Discussion' started by AMG Vilas ®™, Jan 31, 2015.

  1. AMG Vilas ®™

    AMG Vilas ®™ Well-Known Member

    Joined:
    Jan 30, 2015
    Ratings:
    +45 / 0 / -0
    [​IMG]

    leave here your configuration to help some players who do not make a good save configuration, here are plenty of good drivers they lack no good setup
    AUDI R8 ULTRA
     
    • Like Like x 1
    Last edited: Jan 31, 2015
  2. Drei

    Drei Well-Known Member

    Joined:
    Jan 30, 2015
    Ratings:
    +82 / 0 / -0
    car? (probably im just blind, but cant find it....)
     
  3. Tobias Schröder

    Tobias Schröder Well-Known Member

    Joined:
    Jan 29, 2015
    Ratings:
    +273 / 0 / -0
    @Drei
     
    • Funny Funny x 1
  4. PE4

    PE4 Well-Known Member

    Joined:
    Feb 2, 2015
    Ratings:
    +69 / 0 / -0
    Hmm... on front-mid engine cars I use 10 rear wing, softer springs and almost minimum ground clearance.
    Here is a guide I made for amateur difficulty on the non-ADAC Audi:
     
    • Like Like x 1
  5. PaulH

    PaulH Member

    Joined:
    Jan 30, 2015
    Ratings:
    +8 / 0 / -0
    Here,s a lap & setup(at end of vid) I did a while back Audi ADAC 13 Get Real Mode

     
    • Like Like x 2
  6. m.bohlken

    m.bohlken Well-Known Member

    Joined:
    Jan 29, 2015
    Ratings:
    +988 / 0 / -0
    The ADAC '14 Audi R8 is a little bit different to the other Audi R8's... A bit more on the rear wing helps a lot to stabilize the rear of that car. 17 on the rear is maybe a bit to much, but I haven't tried the R8 @ Bathurst.