Simucube2 Settings?

Discussion in 'Hardware' started by reuteman, Jul 13, 2019.

  1. reuteman

    reuteman New Member

    Joined:
    Dec 5, 2018
    Ratings:
    +0 / 0 / -0
    Hello!

    I'm looking for some tips to get a good experience with my simucube2 pro.
    I can't find a good configuration to use it.
    I tried with the configuration of the GraniteDevices forum (Raceroom and Simucube2 post)
    but, really, I can not feel basic things (you know, ripples on the track or kerbs....)

    Any suggestions would be welcome.
     
  2. Vantskruv

    Vantskruv Member

    Joined:
    Oct 9, 2017
    Ratings:
    +23 / 0 / -0
    These are my current settings, mainly calibrated from the Mclaren GT3 car, with the SC2 Pro wheel.

    General force feedback settings:
    Force feedback: on
    Inverted force feedback: off
    Gamepad rumble: off
    Force feedback intensity: 50%
    Smoothing: 0%
    Force feedback spring: 0%
    Force feedback damper: 0%

    Steering force settings:
    Steering force intensity: 50%
    Force feedback minimum force: 0%
    Understeer: 25%
    Vertical force: 70%
    Lateral force: 50%
    Steering rack: 0%

    Force feedback effect settings:
    Slip effect: 40%
    Engine vibrations: 5%
    Kerb vibrations: 0%
    Shift effect: 15%
    Collision effect: 0%

    Truedrive settings are as follows:
    General

    Steering range: 540
    Bump stop range: 540
    Overall strength: 100%
    (Actual max current is 22.8A for my setup)

    Constantly Operating Filters
    Simucube Force Reconstruction Filter: 6
    Torque bandwith limit: Unlimited
    Damping: 22%
    Friction: 25%
    Inertia: 31%
    Static Force Reduction: OFF
    Slew Rate Limit: OFF
    Ultra Low Latency Mode: 20%
    Center frequency Hz: DISABLED

    Direct Input Effects
    Damping: 0%
    Friction: 0%
    Spring: 0%
    Sine Wave: 100%
    Square Wave: 0%
    Sawtooth: 0%
    Triangle: 0%
     
    • Like Like x 1
    Last edited: Oct 27, 2019
  3. Vantskruv

    Vantskruv Member

    Joined:
    Oct 9, 2017
    Ratings:
    +23 / 0 / -0
    Updated my settings in above post.
    Changed Sine Wave from 0% to 100%
    Changed Collision effect from 5% to 0%