This is most noticable with cars in any class that have the safety net When hoping into the drivers seat the net is only partially showing; not fully to the outside edge This can also happen with parts of a car (roll cage and the hans(cockpit side) device on open wheelers) In one extreme case all I had was the dash board of the new Renualt and the windscreen pillar; no roof! The only way to fix this is to rotate through the camera views and then upon returning to driver view the net/hans device will fully show If you move to the next session eg practise to qualify I have to rotate through the cameras again to fix it! This is not limited to one car or class; with out trying them all (but I've tried 10) any car with a saftey net or openwheeler with a hans device has this problem I've noticed the missing graphics on the sidesin the open wheelers before but never tried the rotate camera fix so I think this has been a problem for a while Attached below are a couple of before and after camera rotation screen shots