thanks for your reply! I have tuned the frequencies..trying to get a better response. I will try to tune road vibration, which i see says based on...
I used to get great feedback with kerbs in Simvibe, had a great profile for it, but lost profile in reinstall, and never could get it back after...
If your going to run 4 buttkickers..run in chassis mode(simvibe)..try to keep your buttkicker placement at 4 corners of your rig to get the best...
That's exactly how I mounted mine to my Obutto
I recall at one time dx11 was been looked at from the RRE devs.Is that dead in the water?? I hope not, as it would breath much more life into this...
I have the 4 mini lfe and have never had a issues with overheating?? I have had them well over 4 years with heavy use, I use them everyday.I do...
Can't stress how much this addition to your rig will make!! I have 4 butt kicker mini lfe( may cost more, but well worth it) running from 2 Dayton...
Awwww..dummy me..the steam mirror is on one eye.. switched it to two and sure enough I see the mask♂️♂️ there was talk once about sector 3...
whoops ..just about forgot the image
okay , I did that.Mapped a button to monitor view ..and now I see the mask ..or what very little there is of one??? Is this similar to any others...
I see the mask in rf2..I'm using the use hmd and mirror in the game ..not steam mirror ... where in r3e can you pick to mirror the game? I do not...
Thanks for reply ..unfortunately I do not see that??? I've enabled the steam vr mirror ...but I just see a full image, no corners cut off eg:mask...
Sector 3 devs, would it be possible to implement a mask as rfactor 2 have done to save the processing on areas not visible in headset? Any little...
Separate names with a comma.
